★ Feature 2 ★ Easy to carry out 【 lightweight design 】
★ Features three ★ Large capacity large opening design, suitable installation. It's very convenient.
★ Features four ★ vacuum heat structure design. Strong thermal insulation and cold preservation ability.
★ Features five ★ air vent design, easy to open the cover.
About the use of the pot:
[1.] Before use, be sure to preheat the stew pot with boiling water for 3-5 minutes. (Where the boiling water is poured to the water level of the pot cup, that is, the neck of the cup)
【2.】 Then wash the rice water with warm water, or wash it with tap water, and then use preheated water. Then put the rice in a stew pot, pour in boiling water and stew for about 3-4 hours. That will do. If it takes too long, it will get cold. The stew pot is different from the thermos cup, the durability is not as long as the thermos cup, and the stew pot is mainly due to the high temperature concentration.
[3.] Note that: rice as little as possible, otherwise it will be filled with raw, after all, the capacity of the pot is not as big as the rice cooker (it is good to carry some fingers, do not grab a large) If the dessert, the white fungus should be soaked first, and then cut small. Red dates should be first broken and then braised. All beans need to be frosted first. Because the beans are relatively hard, it is recommended to boil the electric pot first.
Note on the elephant print braising cup:
★ About the cup cover heating ★ Because the image print braising cup cover is designed with a vent, which is designed to prevent the internal pressure from being too high, so there will be temperature conduction to the lid when braising, but this does not affect the braising effect Oh About the internal seam: because of the image print welding process, so there will be a seam at the cup interface, but it is not a quality problem. Do not affect the use of the cup cover slightly loose: like the printing pot top cover does not have much effect, after the stew can not be unscrewed can first open the top cover exhaust, the top cover with a buckle design, as long as the buckle is good, there will be a little Angle of loosening, this is a normal phenomenon, does not affect the use of oh, and certainly will not fall down
